Vandy Vape Mato RDTA
The MaTo RDTA combines the best of rda and rta and cuts an extremely good figure. As usual with a topcoiler, the coiling deck is mounted above the tank, which is of great benefit to the taste. The MaTo is also able to boast dense, compact steam even with moderate battery power from 45 watts.
The deck is postless and designed for one single coil. However, this can be very sporty, as the Mato also holds particularly thick wires with a diameter of up to 6 millimetres.
To shorten the wire ends to the appropriate length, a coil trimmer is included. With this you can trim the ends in eight steps between 4 mm and 11 mm (7 mm is recommended). The coil is then simply inserted into the postholes at the bottom of the deck and fixed with two screws, done!
A real highlight is the airflow system. The tank is designed for DL (Direct Lung), but at the same time the draw resistance is clearly noticeable even with the airflow completely open. Before reaching the coil, the air is guided through 13 small holes on each side and swirled. This technology further intensifies the taste.
Four stainless steel wicks ensure very good liquid flow. The wicks extend from the deck to the tank bottom and reliably transport the liquid upwards even when the tank is almost empty. All you have to do is loosely place the cotton wool on the wicks and you're ready to go.
Also the refilling turns out to be a pleasant affair. By pulling off the top cap, you reach the filling opening protected by a silicone seal.
The tank made of heat-resistant PSU polymer has a capacity of five millilitres. If that's not enough, you can also run your MaTo on a squonker and keep shooting e-liquid. A squonker pin is included.
Besides the excellent steam properties, special attention was paid to the excellent manufacturing quality. The MaTo is of high value and also looks modern and tasteful. For even more style, the components can be exchanged with each other and individualised versions can be put together from the different colours available.
- very good processing quality
- excellent taste
- slightly restrictive draw
- honeycomb airflow with 13 holes per side
- dense, compact steam
- easy to coil
- space for up to 6mm thick wires
- 5ml tank volume
- clean filling
- squonker pin
- Material: stainless steel, heat-resistant PSU
- Dimensions: 54.5 x 24 mm (inkl. drip tip)
- Deck: single coil (postless)
- Capacity: 5 ml
- Inhalation method: DL (Direct Lung)
- Positive Pin: adjustable
- Connector: 510
1 x Vandy Vape Mato RDTA
1 x Ni80 fused clapton coil 0.23 ohm
1 x coil Trimmer
1 x 510 drip tip adapter
1 x squonk pin
1 x replacement steel wire
1 x replacement parts (o-rings, screws)
1 x manual
|Shipping weight:||0,16 Kg|